In environments where GNSS is unavailable or not useful for positioning, the use of low cost MEMS-based inertial sensors has paved a way to a more cost effective solution. Of particular interest is a foot mounted pedestrian navigation system, where zero velocity updates (ZUPT) are used with the standard strapdown navigation algorithm in a Kalman filter to restrict the error growth of the low cost inertial sensors. However heading drift still remains despite using ZUPT measurements since the heading error is unobservable. External sensors such as magnetometers are normally used to mitigate this problem, but the reliability of such an approach is questionable because of the existence of magnetic disturbances that are often very difficult to predict. Hence there is a need to eliminate the heading drift problem for such a low cost system without relying on external sensors to give a possible stand-alone low cost inertial navigation system. In this paper, a novel and effective algorithm for generating heading measurements from basic knowledge of the orientation of the building in which the pedestrian is walking is proposed to overcome this problem. The effectiveness of this approach is demonstrated through three field trials using only a forward Kalman filter that can work in real-time without any external sensors. This resulted in position accuracy better than 5 m during a 40 minutes walk, about 0·1% in position error of the total distance. Due to its simplistic algorithm, this simple yet very effective solution is appealing for a promising future autonomous low cost inertial navigation system.

This paper proposes an integration of ‘building heading’ information with ZUPT in a Kalman filter, using a shoe mounted IMU approach. This is done to reduce heading drift error, which remains a major problem in a standalone shoe mounted pedestrian navigation system. The standalone system used in this paper consists of only single low cost MEMS IMU that contains 3-axis accelerometers and gyros. Several trials represented by regular and irregular walking trials were undertaken inside typical public buildings. The results were then compared with HSGPS solution and IMU+ZUPT only solution. Based on these trials, an average return position error of below 5 m was consistently achieved for an average time of 24 minutes – at times as long as 40 minutes - using only a low cost MEMS IMU.

Zero Velocity Update (ZUPT) is an important update to aid an autonomous inertial pedestrian navigation. The objectives of this paper are to briefly revisit the concept of ZUPT and its importance, testing it on real walking pedestrian and comparing its performance when used with either conventional ‘Dead Reckoning approach (DR)’ or with ‘Kalman Filter approach (KF)’ as either one of these approaches is commonly used in literature. Performances were analyzed further with the inclusion of two correction modes (Linearly Weighted Interpolation and Residual Velocity). Experiments were performed using a low cost Inerital Measurement Unit (IMU) from MicroStrain (3DM-GX1). It was shown that the KF approach outperformed DRonly approach, but comparable performance with KF was noticed when DR is combined with correction mode. Finally, a combination of RV correction mode with forward KF solution was shown to improve the position output